Dependable metal roof installation for Belmar homeowners from Roofing Brothers — measured on site, done on schedule, and cleaned up after.
We have been setting metal panels on houses, churches, barns and additions for over twenty years, and the crews serving Belmar install them the same way we always have. Straight lines, correct fastener spacing, and closures at the ridge so wind driven rain has nowhere to go.
Roofing Brothers has been doing metal roof installation since 2002, first around Morganton, North Carolina and now for Belmar homeowners through our network of local crews. The standard has not moved: measure it right, fasten it right, and never cut a corner where water can find it.
Before any metal roof installation starts in Belmar you will know the price, the material and the schedule. Estimates are always free, and nobody is going to push you to decide while somebody is still standing in your driveway.
How a job actually runs, from the first phone call to the last magnet pass over the driveway.
We measure the roof on site, count the valleys, hips and penetrations, and bring the color chart so you can hold it up against your siding.
Where the decking is sound and there is only one layer, we can often go over the top on purlins. We tell you which one your house calls for.
We keep panels straight to a line rather than to the eye, because a metal roof shows every bit of drift the moment the sun hits it.
Ridge caps, closures, drip edge and gable trim finish the roof and keep wind driven rain and wasps out from under the panels.
Questions homeowners ask us about this kind of work.
Much less than people expect. Over solid decking with underlayment, a Belmar metal roof sounds about like a shingle roof from inside. The loud tin roof people remember was screwed to open purlins on a barn.
Around twenty standard colors. Green, burgundy, bronze, black, gray, tan and barn red are the ones most Belmar homeowners land on. We bring the chart with the estimate so you can hold it against your siding.
Installed properly over sound decking, a metal roof should give a Belmar home 40 to 60 years. Standing seam often goes longer because there are no exposed fasteners to work loose or leak.
A straightforward Belmar house is usually three to five days. A cut up roof with dormers, valleys and multiple pitches takes longer, because every panel and trim piece gets measured and fit on site.
What people said once the job was finished and the trucks were gone.
"Cannot say enough about how careful they were around the flower beds. Everything got covered and nothing was trampled."
"Thank you so much to the entire crew at Roofing Brothers for our amazing new tin roof! You were amazing to work with and I couldn't recommend you to others enough! Great communication, pricing, color options, efficiency, and HONESTY! If anyone needs a new roof, I highly recommend this crew! Phenomenal job."
"Ice was backing up at our eaves every winter. They cleared it, then went back and fixed the ventilation, and we have not had the problem since."